Listning ID 64989 Description
Traverse pneumatic scissor TPGN-250 (canany lift) designed to lift wheels of passenger cars and light trucks up to 2.5 tons. TPGN-250 is widely used to perform angle adjustment of wheel alignment and for maintenance, repair chassis cars. The traverse can be installed on any lift, as on four-post rack, or on a hoist pantograph type, as well as at the observation wells of appropriate sizes and designs, which are equipped with tracks for movement of the traverse. As ways use area with a flange width not less than 50 mm or the channel. The relative height of 280 mm. cross beam is equipped with a retractable paws on the ends of which are threaded stops. Unscrewing of the rod stops, increase the height of the lift car. Installing the rubber "cushion" in the center of the guide box, raise the car in the center. The traverse is supplied by the manufacturer fully assembled. The lift is placed on a traveling path (if necessary, you can adjust the width of the gauge) and tighten the safety screws. It is also possible to adjust the clearance of the bar, moving the rollers above or below. For this, there are three holes in increments of 50 mm. Installing the cross bar in desired location, push the legs into place, provided for the jacks. Glands (potatoville) crane 2 and apply compressed air pressing 3. When lifting the bar, she automatically placed on the locating lugs (two positions). For lowering the car, you must again apply compressed air, sosiologiya stops, and the arm 4 to withdraw the lugs to the side. Then, otvorachivanie 2 1.5-2 turns (counterclockwise). The car is lowered. Maximum load capacity, kg 2500 Working pressure of air, ATM. 6-8 Track width min-max mm 760-1170 The maximum width of the props, 1500 mm. Working stroke , mm 305 Distance between axis, 320 mm. Weight, 118 lbs. Maintenance. Once a month neobhodimosti the test articulated joints, as well as to produce a lubricant truedisabledicon products. It is also necessary to control Provence in the pump. Normal oil level at the lower edge of the tube 6. Probcause a screwdriver etc. Oil hydraulic or И20. Additional information
Reviews
Customer reviews for this ad are not available. We will be very grateful if you leave first. Write to author
Related ads
© 2001-2024 iGazeta tech - web-magazine of ads of Kherson and of Kherson region in all regions of Ukraine (except temporarily occupied territories). All rights reserved. Using this website, including the supply of ad means you accept user agreement . This bulletin board has been working for 15 years on the equipment ordered on the Servers in Ukraine website. |